1060F10 FUEL INJECTORS - Alfa - 156 - eLearn

3237800 - 1060F10 fuel injectors

) Proceed with removal - 1016A10 sound-proofing cover - r + rEnsure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	A1B

1. Disconnect the electrical connections from the injectors.

	Name	Connector
1	Injector	N70

2. Disconnect the electrical connection from the cam angle sensor.

	Name	Connector
2	Timing sensor	K47

3. Disconnect the electrical connection for the air conditioning compressor.

	Name	Connector
3	Air conditioning compressor "on" electromagnet	L20

Release the electrical wiring from the band on the timing cover. 4. Undo the bolts fastening the cable duct and move the electrical wiring aside.

1. Push clips (1a) by hand and disconnect the pipe from the injectors to the fuel recovery manifold (1b), injectors side and move it aside. 2. Undo the connectors (2a), (2b) and remove the pipe from the fuel manifold to the injectors (2c).

Use new pipes from from fuel manifold to injectors upon reassembly.

1. Undo the nuts fixing the injector brackets.2. Remove the injectors (2a) complete with bracket using the tool (2b).

If the same injectors are being reused, mark the cylinder to which they belong so that they can be correctly refitted.

If new fuel injectors are fitted:

determine the identification code stamped on the top;
check that the new injectors(s) is (are) recognized by the engine management control unit using the Examiner.

Start the removal beginning with the injector for cylinder no. 1 and continuing with the injectors for cylinders 2, 3 and 4.

	Name	Country
2b	Extractor	1.870.897.300

Refitting ( Removing

) 1. Refit the injectors (1a) complete with brackets and secure by tightening the nuts (1b) to the specified torque.

Start the refitting beginning with the injector for cylinder no. 4 and continuing with the injectors for cylinders 3, 2 and 1.

	Fastening	Component	Ø	Value(daNm)
1b	Nut	INJECTORS(DIESEL)	M8	(Camshaft housing side 23 28

1. Fit the new pipes from the fuel manifold to the injectors and secure them using the connectors without tightening them. 2. Tighten the connectors for the pipes from the fuel manifold to the injectors, injector side, to the recommended torque using a suitable spanner.

	Fastening	Component	Ø	Value(daNm)
2	Connector	FUEL MANIFOLD LINE TO INJECTORS	M12	(Injector side 22 24

3. Tighten the connectors for the pipes between the fuel manifold and the injectors, fuel manifold side, to the recommended torque using a suitable spanner.

	Fastening	Component	Ø	Value(daNm)
3	Connector	FUEL MANIFOLD LINE TO INJECTORS	M12	Fuel manifold side 22 24

Clean the threaded seats for the above-mentioned pipe on the manifold and the injectors using heptane.

4. Connect the pipe from the injectors to the fuel recovery manifold (4a) to the injectors pushing it until the clips (4b) can be heard clicking into place.

Place the electrical wiring back in its housing and tighten the cable duct fixing bolts. Fasten the electrical wiring using the band on the timing cover. Connect the electrical connection to the air conditioner compressor. Connect the electrical connection to the cam angle sensorConnect the electrical connections to the injectors.Connect the negative (-) battery terminal Proceed with refitting - 1016A10 sound-proofing cover - r + r