3239187 - 7010A Location of rear door wind noise

Tape the various areas shown in the diagram using masking tape. Road test the vehicle letting it gradually reach the speed where the noise appears: if the noise persists, carry out the preliminary location test on the entire vehicle (see  See Test 70  Location of wind noise (preliminary location) ). Remove the masking tape from zone A and repeat the road test: if the noise persists, adjust the door hinges (see Op.   7010A14  rear side door - adjust centering and moulding - includes adaptation of hinges and seals on door compartment ). Remove the shims from the upper hinge or add shims to the lower hinge so that the door adheres better to the seal. Remove the masking tape from zone B and repeat the road test: if the noise persists, adjust the door hinges (see Op.   7010A14  rear side door - adjust centering and moulding - includes adaptation of hinges and seals on door compartment ). Remove or add shims for the two hinges, so that the door adheres better to the seal. Remove the masking tape from zone C and repeat the road test; if the noise persists, check the condition of the rear handle and, in particular, the presence of the seal around the lever (see Op.   7010C11  rear side door outside handle-r r ). Remove the masking tape from zone D and repeat the road test: if the noise persists, check the condition of the door housing seal in that area and that it adheres correctly to the bodyshell (see Op.   7010A34  rear side door compartment seal r r ); also check that the window seal is correctly matched (with the window closed). Remove the masking tape from zone E and repeat the road test: if the noise persists, check the condition of the glass scraper (see Op.   7010D26  rear side descending window glass scraper (outer) r r ).