0010T12 ENGINE OIL AND FILTER REPLACE - Alfa - 156 - eLearn

3237406 - 0010T12 engine oil and filter replace

Engine oil is harmful to the skin: minimize contact of the oil with the skin; in case of contact wash with soap and water.

Position the vehicle on the ramp.1. With the engine hot, remove the filler cap.2. Withdraw the oil level dipstick.

Proceed with removal Refer to op.. 7055B54 under-engine guard - r r . 1. Undo the drain plug on the engine sump and drain the oil fully into a suitable container.

Be careful when removing the drain plug, as the oil could be very hot.

Do not disperse the oil into the environment, as indiscriminate dispersal of this product causes pollution.

Proceed with removal Refer to op.. 1076A46 heat shield for catalytic preconverter r r . 1. Remove the cartridge engine oil filter (1a) using the tool (1b).

Recover the engine oil which comes out in a suitable container.

	Name	Country
1b	Self-tightening spanner	1.871.001.200

Clean the drain plug and screw it on, with its seal, to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	-	ENGINE OIL DRAIN PLUG	M18	(Crankcase sump side) 1.8 ÷ 2.2

Lubricate the gasket of the new oil filter with engine oil and screw on the filter fully by hand. Proceed with refitting Refer to op.. 1076A46 heat shield for catalytic preconverter r r . Proceed with refitting Refer to op.. 7055B54 under-engine guard - r r . Refill the engine lubrication circuit using the recommended oil.

	Type	Component	Name	Qty.
-	Oli [l]	ENGINE LUBRICATION CIRCUIT	SELENIA TURBODIESEL	5

The table shows the quantity for periodic replacement.

For optimum operation of the engine in particularly harsh climatic conditions (temperatures below -15 degrees C), use the recommended oil for the engine lubrication circuit.

	Type	Component	Name	Qty.
-	Oli [l]	ENGINE LUBRICATION CIRCUIT	SELENIA WR DIESEL	5

The table shows the quantity for periodic replacement.

When refilling with engine oil, take the utmost care to avoid oil spilling accidentally into the alternator ventilation slots, so as to avoid damaging the alternator and prevent the possibility of fire.

Check that the engine oil level on the dipstick is correct.

The oil level should be checked with the vehicle on flat ground. If the oil level is higher than the MAX mark, it could cause excessive evaporation of the oil and a loss of pressure.

Refit the filler cap, run the engine at idle speed for about 2 minutes, turn off the engine and wait a few minutes. Check the oil level and that there are no leaks.Remove the car from the ramps.