3238019 - 2710A10 drive shaft with joints (one), l/h or r/h - r + r
Removing
(
Refitting
)
- 4410A80 damper lower fork -
r r - 4450B10 Front WHEEL (one) - R.R. - 7055B64 Engine compartment DUST shield in front wheel arch
(one), left or right - R.R.1. Remove the bevel and undo the nut fixing the driveshaft to the
wheel hub.2. Undo the bolts (2a) and remove the half shaft (2b) complete with
joints. | The bolts securing the front half shafts, intermediate half shaft/differential inner half shaft side, have been treated with Eslok type locking compound; therefore every time they are removed they must be replaced. |
Removing
(
Refitting
)
PROCEED AS FOLLOWS FOR THE LEFT DRIVESHAFT.
Proceed with removal
- 7055B54 under-engine guard -
r r
.
Proceed with removal
- 4450B02 left front wheel r r
.
Proceed with removal
- 7055B90 Left front WHEEL ARCH
LINER - R.R.
.
Proceed with removal
- 4410A80 damper lower fork -
r r
(Left side).
PROCEED AS FOLLOWS FOR THE RIGHT DRIVESHAFT.
Proceed with removal
- 7055B54 under-engine guard -
r r
.
Proceed with removal
- 4450B04 right front wheel r
r
.
Proceed with removal
- 7055B66 Engine compartment DUST
SHIELD protection in right front wheel arch - R.R.
.
Proceed with removal
- 7055B91 Right front WHEEL ARCH
LINER - R.R.
.
Proceed with the removal
- 4410A80 damper lower fork -
r r
(Right side).
WORK IN THE SAME WAY FOR BOTH DRIVESHAFTS.1. Remove the bevel and undo the nut fixing the driveshaft to the
wheel hub.2. Loosen the band (2a) and remove the driveshaft (2b) complete
with joints.
Refitting
(
Removing
)
Place the driveshaft complete with joints
back in its housing and secure it using a new band.1. Tighten the nut (1a) for the driveshaft to the wheel hub to the
recommended torque using the tool (1b) for angular tightening. | Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| 1a | Nut | FRONT DRIVE SHAFT COMPLETE WITH JOINTS | M24 | (Wheel hub side) 6.6 ÷ 7.3 + 62? ± 2 ? |
 | Name | Country |
|---|---|---|
| 1b | Protractor | 1.820.622.000 |
