| | Results of the tests |
| 0 | PRELIMINARY CHECKS | All OK | Problems met | Operation |
|---|
| Firstly
check the moving window glass is properly closed.
Check that the wind noise does in fact come from one of the rear
doors by carrying out the test for preliminary wind noise localisation
See Test 70A Location of wind noise (preliminary location) |
Continue to Step
1
| The wind noise comes from another
area | Check
the diagnostic table corresponding to the area located. |
| 1 | CHECK THE DUST SEALING STRIP
ON THE DOOR | All
OK | Problems
met | Operation |
|---|
| Check
that the wind/dust seal is fitted correctly |
Continue to Step
2
| Lower seal installation
defective |
Fit the sealing strip correctly
Op. 7010A46 |
| Wind strip incorrectly fitted |
Fit the sealing strip correctly
Op. 7010A50 |
| 2 | CHECK LOCATION OF WIND NOISE FROM
THE REAR DOORS | All OK | Problems met | Operation |
|---|
|
Carry
out the test for detailed localisation of wind noise from the rear
doors
See Test 7010A Location of rear door wind noise
and
locate the area from which the noise originates.
| No wind noise is located
Continue to Step
3
| The window noise comes
from the upper area of the central pillar |
Adjust the door hinges
Op. 7010A14 |
| The wind noise comes from the lower area of the central
pillar |
Adjust the door hinges
Op. 7010A14 |
| The wind noise comes from the handle |
Check the condition of the rear handle and make sure
that it is correctly fitted, in particular checking that the adhesive
foam is around the lever; renew or replace the actual handle
Op. 7010C11 |
| The wind noise comes from the rear pillar area |
Check the condition of the door compartment seal in that
area and ensure it is bonded properly to the body
Op. 7010A34 |
| The wind noise comes from the glass scraper area |
Check the glass scraper is undamaged and correctly fitted
Op. 7010D26 |
| 3 | CHECK CORRECT OPERATION | All OK | Problems met | Operation |
|---|
| Check
that the fault is no longer present | End of diagnosis | Fault persists | |