3237610 - 1084A42 engine oil pressure warning light switch - r + r

Removing ( Refitting )  - 1008C10  power unit upper reaction link r r - 4450B10  Front WHEEL (one) - R.R. - 7055B64  Engine compartment DUST shield in front wheel arch (one), left or right - R.R. - 7055B54  under-engine guard - r r - 1092G10  single engine belt r r - 1008B10  power unit front mount (timing side) flexible block - replace1. Undo the lower alternator fixing bolt.2. Loosen the upper bolt (2a), then rotate the alternaor (2b) upwards and fix it in this position with the upper bolt.
1. Disconnect the electrical connection from the engine oil pressure warning light switch.

NameConnector
1Engine oil pressure sensor  K30 
2. Remove the engine oil pressure warning light switch.
Refitting ( Removing ) Fit the engine oil pressure warning light switch.Connect the electrical connection to the engine oil pressure warning light sensor.Loosen the upper bolt and place the alternator back in its housing.Fit the lower bolt fixing the alternator and tighten it together with the upper bolt. - 1008B10  power unit front mount (timing side) flexible block - replace - 1092G10  single engine belt r r - 7055B54  under-engine guard - r r - 7055B64  Engine compartment DUST shield in front wheel arch (one), left or right - R.R. - 4450B10  Front WHEEL (one) - R.R. - 1008C10  power unit upper reaction link r r Removing ( Refitting ) Position the vehicle on the ramp. Proceed with the removal  - 7055B54  under-engine guard - r r . Proceed with the removal  - 1076B50  exhaust pipe attachment to engine - r + r . 1. Release the lambda sensor and knock sensor electrical wiring from the fastening on the modular intake manifold.
1. Undo the bolts (1a) and remove the modular intake manifold mounting bracket (1b) after having released it from the alternator electrical wiring.
1. Disconnect the electrical connection from the engine oil pressure warning light switch.

NameConnector
1Engine oil pressure sensor  K30 
2. Undo and remove the engine oil pressure warning light switch.
Refitting ( Removing ) Fit the engine oil pressure warning light switch in its seating and tighten it to the recommended torque.

FasteningComponentØValue(daNm)
--OIL PRESSURE W/LM14(Engine crankcase side) 2.5 ÷ 3.1
Connect the electrical connection for the engine oil pressure warning light switch.Place the modular intake manifold mounting bracket back in its housing and secure it using the bolts.Secure the alternator electrical wiring to the band on the modular intake manifold mounting bracket.Secure the electrical wiring for the lambda sensor and knock sensor to the fastening on the modular intake manifold. Proceed with the refitting  - 1076B50  exhaust pipe attachment to engine - r + r . Proceed with the refitting  - 7055B54  under-engine guard - r r . Position the vehicle on the ramp.