3237406 - 0010T12 engine oil and filter replace

Engine oil is harmful to the skin: minimize contact of the oil with the skin; in case of contact wash with soap and water.

Position the vehicle on the ramp.Remove the filler cap with the engine hot.Withdraw the oil level dipstick.Raise the car.Undo the drain plug on the engine sump and drain the oil fully into a suitable container.

Be very careful whilst removing the drain plug; the oil could be very hot.

Do not disperse the oil into the environment, as indiscriminate dispersal of this product causes pollution.

Working under the vehicle, use the specific wrench to release the oil filter and remove it. Clean the drain plug and screw it on, with its seal, to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Plug	ENGINE OIL DRAIN PLUG	M18	1.7 - 2.1

Dampen the gasket of the new oil filter with engine oil and screw on the filter fully by hand. Lower the vehicle. Refill the engine with oil.

	Type	Component	Name	Qty.
-	Oli [l]	ENGINE LUBRICATION CIRCUIT	SELENIA TURBODIESEL	4.2

For optimum operation of the engine in particularly harsh climatic conditions (temperatures below -15 degrees C), use the recommended oil for the engine lubrication circuit.

	Type	Component	Name	Qty.
-	Oli [l]	ENGINE LUBRICATION CIRCUIT	SELENIA WR DIESEL	4.2

Check that the engine oil level on the dipstick is correct.

The oil level should be checked with the vehicle on flat ground. If the oil level is higher than the Max mark, it could cause excessive evaporation of the oil and a loss of pressure.

Refit the filler cap, run the engine at idle speed for about 2 minutes, turn off the engine and wait a few minutes. Check the oil level and that there are no leaks.Remove the car from the ramps.

Engine oil is harmful to the skin: minimize contact of the oil with the skin; in case of contact wash with soap and water.

Engine oil is harmful to the skin: minimize contact of the oil with the skin; in case of contact wash with soap and water.