3239024 - 7210A16 R.R. WING LOWER CROSSMEMBER

Removing ( Refitting )  - 7210A15  R.R. HEADLAMP HOUSING/FRONT WING CROSSMEMBER . Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).Straighten the body if necessary. 1. Use a pneumatic saw to cut along the lines shown in the figure.Remove the front beam from its seat. 1. Use a rotary brush to clean the areas in order to expose the weld spots.2. Use a chamfering machine to remove the spot welds.3. Drill out the weld spots.Remove the excess sheet steel using a hammer and chisel. Use a grinding wheel to remove the spot weld residues.1. Apply the electric weld paint finish. Use a rotary brush to remove the corrosion-proofing from around the inner and outer edge of the part.1. Apply the electric weld paint finish to edges in contact with the car. Refitting ( Removing ) 1. Fit the part correctly using self-locking clips.2. Use a spot welder to weld the areas shown in the figure. 1. Fit the part correctly using self-locking grippers.2. Use a spot welder to weld the areas shown in the figure. 1. Use a grinding wheel to level weld residues and remove.Use a rotary brush to clean the newly-welded areas.Check that the welded parts are correctly positioned. 1. Spread rust-proofing inside the beam.Apply paint.Apply wax.  - 7210A15  R.R. HEADLAMP HOUSING/FRONT WING CROSSMEMBER .