3237897 - 1820B20 (Pump) - MASTER CYLINDER R.R.

Removing ( Refitting ) Position the vehicle on the ramp Proceed with removal  - 1016A10  sound-proofing cover - r + r Proceed with removal  - 5530B10  battery - r+r Proceed with removal - 5530B54 battery cover - r+r Proceed with removal  - 7055B54  under-engine guard - r r1. Remove the cap on the bleed valve.2. Connect the collection system (pipe and reservoir) to the bleed valve on the hydraulic clutch actuator. 3. Lift the retaining clip (3a) and withdraw the bleed device (3b) as much as necessary.Let the hydraulic clutch system drain completely. 1. Raise retaining clip (2a) and disconnect the clutch hydraulic circuit vibration damper (1b), clutch master cylinder side. Remove the sound-proofing protection.1. Remove the split pin (1a) and disconnect the master cylinder rod (1b) from the clutch pedal.2. Disconnect the hose from the clutch reservoir to the master cylinder on the master cylinder side.3. Undo the nuts (3a) and remove the master cylinder (3b). Refitting ( Removing ) Place the clutch master cylinder back in its housing and fix it tightening the nuts to the recommended torque.Connect the hose from the clutch reservoir to the master cylinder on the master cylinder side.Connect the master cylinder rod to the clutch pedal and secure it with its split pin.Place the rubber protection back in its housing.Connect the clutch hydraulic circuit vibration damper, master cylinder side - and secure with the retaining clip. Proceed with refitting - 0010T64 brake and or clutch fluid check level and top up as necessary Proceed with refitting  - 0010T67  hydraulic clutch system bleed air Proceed with refitting  - 7055B54  under-engine guard - r r Proceed with refitting - 5530B54 battery cover - r+r Proceed with refitting  - 5530B10  battery - r+r Proceed with refitting  - 1016A10  sound-proofing cover - r + rRemove the car from the ramps.