3237919 - 1820B58 clutch hydraulic circuit vibration damper - r+r

Removing ( Refitting ) Position the vehicle on the ramp Proceed with removal  - 1016A10  sound-proofing cover - r + r Drain the air conditioner coolant circuit - 0010T84 coolant for air conditioning system dehydrate and recharge . Proceed with removal  - 5530B10  battery - r+r Proceed with removal  - 5530B52  Battery DRIP TRAY/SUPPORT - R.R. Proceed with removal - 5530B54 battery cover - r+r Proceed with removal  - 7055B54  under-engine guard - r r Proceed with removal  - 4450B02  left front wheel r r Proceed with removal - 7055B90 Left front WHEEL ARCH LINER - R.R. Proceed with removal  - 5040A72  evaporator outlet pipe - r rPosition a hydraulic jack under the gearbox1. Undo the bolt fixing the power unit gearbox side rigid support to the flexible mounting. Lower the hydraulic jack until the drive shaft joint is resting on the front suspension crossmember.Remove the hydraulic jack from under the gearbox
1. Remove the cap on the bleed valve.2. Connect the collection system (pipe and reservoir) to the bleed valve on the hydraulic clutch actuator. 3. Lift the retaining clip (3a) and withdraw the bleed device (3b) as much as necessary.Let the hydraulic clutch system drain completely.4. Raise retaining clip (4a) and disconnect the clutch hydraulic circuit vibration damper (4b), flexible pipe side.
1. Raise retaining clip (1a) and disconnect the clutch hydraulic circuit vibration damper (1b), master cylinder side.
1. Remove the hydraulic circuit vibration damper by withdrawing from the wheel compartment.
Refitting ( Removing ) Place the hydraulic clutch circuit vibration damper back in its housing, connect it on the master cylinder side and secure it using the retaining clip.Connect the clutch hydraulic circuit vibration damper, flexible pipe side - and secure with the retaining clip.Position a hydraulic jack under the gearboxUsing the hydraulic jack, place the gearbox side rigid power unit support in contact with the flexible mounting. 1. Undo the bolt fixing the gearbox side rigid power unit support to the flexible block to the specified torque.

FasteningComponentØValue(daNm)
1----
Remove the hydraulic jack from under the gearbox
Proceed with refitting  - 5040A72  evaporator outlet pipe - r r Proceed with refitting - 7055B90 Left front WHEEL ARCH LINER - R.R. Proceed with refitting  - 4450B02  left front wheel r r Proceed with refitting - 0010T64 brake and or clutch fluid check level and top up as necessary Proceed with refitting  - 0010T67  hydraulic clutch system bleed air Proceed with refitting  - 7055B54  under-engine guard - r r Proceed with refitting - 5530B54 battery cover - r+r Proceed with refitting  - 5530B52  Battery DRIP TRAY/SUPPORT - R.R. Proceed with refitting  - 5530B10  battery - r+r Fill the air conditioner coolant circuit - 0010T84 coolant for air conditioning system dehydrate and recharge . Proceed with refitting  - 1016A10  sound-proofing cover - r + rRemove the car from the ramps.