1060G42 CLUTCH PEDAL SWITCH - R R - Alfa - GT - eLearn

125001055 - 1060G42 CLUTCH PEDAL SWITCH - R R

) Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	See A1B BATTERY ( BATTERY NEGATIVE )

1. Disconnect the electrical connection from the switch on the clutch pedal.

	Name	Connector
1	Clutch pedal switch	See I31 CLUTCH PEDAL SWITCH ( FRONT )

2. Turn the switch clockwise through 90 degrees and remove.

Refitting ( Removing

) Press the clutch pedal, then refit the clutch pedal switch and turn through 90 degrees anticlockwise until it clicks home on the detent ridge.Press the clutch pedal through its full travel to allow the switch to settle.Release the clutch pedal and pull back to the end of its travel (rest position).

If the switch is not fully back, it could hold the clutch pedal forward and prevent the hydraulic clutch circuit filling properly.

Connect the electrical connection to the switch on the clutch pedal.Connect the negative (-) battery terminal