Removing
(
Refitting
)
Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).If necessary, straighten the body before removing the part.
1. Undo the bolts shown in the figure.2. Remove the headlamp housing beam from the car.
Refitting
(
Removing
)
1. Provisionally position part (1a) on the car and screw in retaining bolts (1b) without tightening.2. Fit bonnet lid catch (2a) and both end stops (2b).
1. Lower the bonnet lid. Check it is properly aligned and that the gap around the edge is even.
Paint the headlamp housing beam in accordance with the specified cycle.Fit both end stops to the headlamp housing beam.
Removing
(
Refitting
)
Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).If necessary, straighten the body before removing the part.
