125000586 - K143 ONE WARNING LIGHT ACTIVATED BY STEERING COLUMN SWITCH UNIT NOT WORKING

When the lights are switched on from the stalk unit, the relevant warning light on the instrument panel does not come on.
The warning lights activated from the stalk unit are:
Side/number plate lights Main beam headlamps Direction indicators Cruise Control (if fitted))
Results of the tests
0PRELIMINARY CHECKSAll OKProblems metOperation

With the ignition on, operate all the lights in question from the stalk unit, i.e.:

  • With the ring nut, side/number plate lights
  • With the lever, main beam headlamps (both on permanently and flashing)
With the lever, direction indicators (right and left)and check that they come on		Continue to Step 1The side lights are not workingContinue as instructedSee table    See table I01 SIDE LIGHTS/NO. PLATE LIGHTS NOT WORKING
The main beam headlamps do not workContinue as instructedSee table    See table I06 MAIN BEAM HEADLAMPS NOT WORKING
Direction indicators not working.Continue as instructedSee table    See table I10 DIRECTION INDICATORS / HAZARD WARNING LIGHTS / NOT WORKING
2.0 JTS3.2 V61.9 JTD 16V

With the ignition on, operate all the lights in question from the stalk unit, i.e.:

  • With the ring nut, side/number plate lights
  • With the lever, main beam headlamps (both on permanently and flashing)
With the lever, direction indicators (right and left)and check that they are activated.Also carry out a road test, activating the Cruise Control and checking that it is working properly		Continue to Step 1The side lights are not workingContinue as instructedSee table    See table I01 SIDE LIGHTS/NO. PLATE LIGHTS NOT WORKING
The main beam headlamps do not workContinue as instructedSee table    See table I06 MAIN BEAM HEADLAMPS NOT WORKING
Direction indicators not workingContinue as instructedSee table    See table I10 DIRECTION INDICATORS / HAZARD WARNING LIGHTS / NOT WORKING
The Cruise Control is not workingContinue as instructedSee table    See table D70 CRUISE CONTROL NOT WORKING UNDER ANY CONDITIONS
1CHECK WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation
Connect the diagnostic equipment and check the operation of the warning lights in question at the INSTRUMENT PANEL NODE through active diagnosisEnd of diagnosisThe warning lights do not come onReplace the instrument panel Op.    Op. 5560B11 ANALOGUE CONTROL PANEL - R+R OR REPLACE