| | Results of the tests |
| 1 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socketCheck that there are no faults in the climate control control unit. | Continue to Step 2 | An error is detected in the control unit | Continue following the instructions for the diagnostic equipment |
| Communication lost with control unit - CAN error | Restore connection between climate control system control unit and body computer See See E6020 AIR CONDITIONING |
| 2 | ACTIVE DIAGNOSIS WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Using the diagnostic equipment (Examiner or other instruments), carry out the active diagnosis for the mixture motor | Continue to Step 3 | Mixture motor connection faulty | Restore the connections See See E6020 AIR CONDITIONING |
| Mixture motor faulty | Replace the motor Op. Op. 5040D88 CONTROL MOTOR OF ANY FLAP - R R WITH AIR CONDITIONER CASING REMOVED |
| Fault in mixing ports | Replace the mixing motor flaps Op. Op. 5040C24 AIR CONDITIONER BOX - DISMANTLE AND REBUILD AT BENCH |
| 3 | CHECKING HEATER RADIATOR | All OK | Problems met | Operation |
|---|
| 1.9 JTD 16VTwo-zone climate control system | Check the seal of the heater radiator | Continue to Step 4 | Pipe from condenser to drier filter damaged | Replace the pipe Op. 5040A52 |
| Pipes to compressor damaged | Replace the pipes Op. 5040A74 |
| Pipes to evaporator damaged | Replace the pipes Op. 5040A78 |
| Radiator dirty or obstructed | Clean the radiator, if necessary, replace it Op. 5040C54 |
| 2.0 JTSTwo-zone climate control system | Check the seal of the heater radiator | Continue to Step 4 | Pipe from compressor to condenser damaged | Replace the pipe Op. Op. 5040A50 PIPE FROM COMPRESSOR TO AIR CONDITIONER CONDENSER - R+R |
| Pipe from condenser to drier filter damaged | Replace the pipe Op. 5040A52 |
| Pipe from drier filter to evaporator inlet pipe damaged | Replace the pipe Op. 5040A56 |
| Evaporator inlet pipe | Replace the pipe Op. 5040A57 |
| Compressor inlet pipe | Replace the pipe Op. Op. 5040A73 COMPRESSOR INLET PIPE - R R |
| Pipes to evaporator damaged | Replace the pipes Op. 5040A78 |
| Radiator dirty or obstructed | Clean the radiator, if necessary, replace it Op. 5040C54 |
| 3.2 V6Two-zone climate control system | Check the seal of the heater radiator | Continue to Step 4 | Pipe from compressor to condenser damaged | Replace the pipe Op. Op. 5040A50 PIPE FROM COMPRESSOR TO AIR CONDITIONER CONDENSER - R+R |
| Pipe from condenser to drier filter damaged | Replace the pipe Op. 5040A52 |
| Pipe from drier filter to evaporator inlet pipe damaged | Replace the pipe Op. 5040A56 |
| Compressor inlet pipe | Replace the pipe Op. Op. 5040A73 COMPRESSOR INLET PIPE - R R |
| Pipes to evaporator damaged | Replace the pipes Op. 5040A78 |
| Radiator dirty or obstructed | Clean the radiator, if necessary, replace it Op. 5040C54 |
| 4 | CHECK ON CORRECT OPERATION | All OK | Problems met | Operation |
|---|
| Check that the fault is no longer present | End of diagnosis | . | |