125001281 - 2127C18 PIPE FROM HYDRAULIC CIRCUIT FLUID RESERVOIR TO HYDRAULIC SPEED SELECTION DRIVE PUMP - R R (Smart gearbox)

Removing ( Refitting )

  • Position the vehicle on a lift.
  • Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).
DescriptionConnector
-Battery See A001 Battery

  • Remove the gear selection electro-hydraulic system hydraulic circuit fluid reservoir cap.

  • Drain the gear selection electro-hydraulic system hydraulic circuit fluid reservoir.

  • Loosen the band and disconnect the pipe from the hydraulic circuit fluid reservoir to the gearbox electro-hydraulic selection pump, reservoir side.

  • Loosen the band and disconnect the cold air intake pipe from the air filter.

  • Working in the space created by removing the light cluster, undo the connector (1a) and disconnect the pipe from the hydraulic circuit fluid reservoir to the gearbox electro-hydraulic selection pump (1b), pump side and remove it.
Refitting ( Removing )

  • Place the pipe from the hydraulic circuit fluid reservoir to the gearbox electro-hydraulic selection pump (1a) back in its housing, connect it to the pump and tighten the connector (1b) to the recommended torque.
FasteningComponentØ  Value (daNm)
1bConnectorPIPE FROM RESERVOIR TO PUMPM14(Pump side) 0.8 - 1.3