125001293 - 2127E50 HYDRAULIC SELECTION GEARBOX CIRCUIT PRESSURE SENSOR - R R (Smart gearbox)

Removing ( Refitting )

• Connect the Examiner diagnostic equipment.
• Select "Alfa Selespeed" on the Examiner.
• Select "Control unit test" on the Examiner and select "Marelli Selespeed automatic transmission" as the system.
• Press "Active diagnosis" on the Examiner and select "Accumulator depressurization".
• Follow the procedure indicated by the Examiner.
•     Op. 5530B10 BATTERY - R+R
•     Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R.

1. Disconnect the electrical connection from the electro-hydraulic selection gearbox hydraulic circuit pressure sensor.

	Description	Connector
1	Pressure sensor on gearbox	See K96 PRESSURE SENSOR ON TRANSMISSION

2. Undo the electro-hydraulic selection gearbox hydraulic circuit pressure sensor and remove it. Refitting ( Removing )

• Place the electro-hydraulic selection gearbox hydraulic circuit pressure sensor back in its housing and tighten it to the recommended torque.

	Fastening	Component	Ø	Value (daNm)
-		HYDRAULIC CIRCUIT PRESSURE SENSOR		1.0 daNm

• Connect the electrical connection to the electro-hydraulic selection gearbox hydraulic circuit pressure sensor.
•     Op. 0010T47 HYDRAULIC SYSTEM FLUID FOR GEARBOX WITH HYDRAULIC SELECTION CHECK LEVEL AND TOP UP IF NECESSARY
•     Op. 0010T48 HYDRAULIC SYSTEM FOR GEARBOX WITH HYDRAULIC SELECTION BLEED AIR
•     Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R.
•     Op. 5530B10 BATTERY - R+R