3310A30 FRONT BRAKE CALIPER ONE R R - Alfa - GT - eLearn

125001312 - 3310A30 FRONT BRAKE CALIPER ONE R R

) Position the vehicle on the rampEnsure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	See A1B BATTERY ( BATTERY NEGATIVE )

Proceed with removal Op. 4450B10 TYRE INFLATION VALVE CAP - REPLACEProceed with removal1. Remove the clip securing the brake caliper to the bracket. Op. 3330E10 L/H OR R/H HOSE (ONE) TO FRONT BRAKE CALIPERS - R+R2. Disconnect the electrical connections for the brake pad wear cable.3. Remove the protective plugs (3a), undo the bolts (3b), then remove the front brake caliper (3c) with the pads.

	Name	Connector
2	Left brake pad wear sensor switch	See K20 LEFT BRAKE PAD WEAR SENSOR SWITCH ( FRONT )

Refitting ( Removing

) .

When fitting a new brake caliper, the latter is supplied to Parts with no brake fluid; it is therefore necessary to operate as follows:- slacken the bleed screw;- insert the end of a transparent tube in the hole on the bleed screw;- using a normal container with recommended brake fluid, insert brake fluid into the caliper until air bubbles emerge from the threaded hole where the hose is connected;- tighten the bleed screw.

Refit the front brake caliper complete with pads in its seating, tighten the bolts to the specified torque and fit the protective plugs.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT BRAKE CALIPER ASSEMBLY	M12	(Bracket side) 11.7

Connect the electrical connection for the brake pad wear cable.Refit in its seating the clip securing the brake caliper to the bracket.Proceed with refitting Op. 3330E10 L/H OR R/H HOSE (ONE) TO FRONT BRAKE CALIPERS - R+R.Top up the brake-clutch fluid level Op. 3330A14 FRONT OR REAR HYDRAULIC BRAKE SYSTEM - BLEED.Proceed with refitting Op. 4450B10 TYRE INFLATION VALVE CAP - REPLACE.Connect the negative (-) battery terminal