125000891 - 1016A20 SINGLE CAM COVER - R + R AND REPLACE GASKET

Removing ( Refitting ) Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	See A1B BATTERY ( BATTERY NEGATIVE )

Proceed with removal    Op. 1016A40 IGNITION COIL COVER ON CYLINDER HEAD- R+R.1. Disconnect the electrical connections from the ignition coils.

	Name	Connector
1	Ignition coil	See A30 IGNITION ''COIL

2. Undo nut (2a) and disconnect earth lead (2b) from the cam cover.

	Name	Connector
2b	Earth on engine	See C40 ENGINE EARTH

3. Undo the bolts (3a) and move wiring duct (3b) aside. 1. Undo the bolts (1a) and remove the ignition coil (1b). 1. Release the fuel vapour supply pipe to the high-pressure fuel pump (1a) from the band (1b) on the tappet cover.2. Undo the bolt (2a) and disconnect the connector (2b) for the vapour recovery pipes from the tappet cover. 1. Undo the bolts (1a) and remove the tappet cover (1b), complete with seal. Refitting ( Removing ) 1. Refit the cam cover (1a), complete with a new gasket and secure it by tightening the bolts (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	CAM COVER	M6	(Cylinder head side) 0.8 ÷ 1.0

Connect the vapour recovery pipe connector to the tappet cover and tighten the relevant bolt.Secure the fuel supply pipe to the high-pressure pump to the band on the tappet cover.1. Place the ignition coils (1a) back in their housings and secure them by tightening bolts (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	IGNITION COIL/REEL	M6	(Tappet cover side) 0.8 ÷ 1.0

Refit the wiring duct and secure with bolts.Connect the earth lead to the tappet cover and secure it with its bolt.Connect the electrical connections to the ignition coils.Proceed with refitting    Op. 1016A40 IGNITION COIL COVER ON CYLINDER HEAD- R+R.Connect the negative (-) battery terminal.