1040A70 SUBMERGED PUMP ASSEMBLY COMPLETE WITH LEVEL GUAGE CONTROL - R + R - Alfa - GT - eLearn

125001005 - 1040A70 SUBMERGED PUMP ASSEMBLY COMPLETE WITH LEVEL GUAGE CONTROL - R + R

) .

If the submerged pump assembly complete with levle gauge is being scrapped, the fuel must always be drained following the instructions described below:whilst extracting the submerged pump assembly draw off the fuel in the chamger using an (electric or manual) pump in line;completely extract the submerged pump assembly and, working on a special workbench, connect an (electrical or manual) in line pump to the connector;activate the pump for the time required to collect most of the fuel inside the filter.

Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal.

	Description	Connector
-	Battery	See A1B BATTERY ( BATTERY NEGATIVE )

Proceed with the removal Op. 7040H80 PARCEL RACK.Proceed with the removal Op. 7040B10 LOAD PLATFORM (LUGGAGE PLATFORM) TRIM - R+R.Proceed with the removal Op. 7050A13 SPLIT REAR SEAT LEFT SQUAB R R.Proceed with the removal Op. 7050A15 SPLIT REAR SEAT RIGHT SQUAB R R.Proceed with the removal Op. 7050A22 REAR SEAT CUSHION - R+R.1. Undo the bolts (1a) and move the access cover (1b) for the submerged pump assembly complete with level gauge sideways.

1. Disconnect the electrical connection from the submerged pump assembly complete with level gauge.

	Description	Connector
1	Fuel pump and level gauge	See N40 FUEL PUMP AND SENDER UNIT

2. Undo the bolts (2a) and the nuts (2b) and remove the reinforcement plate (2c).3. Disconnect the rapid connector for the fuel supply pipe from the submereged pump assembly complete with level gauge.

1. Undo the ring nut (1a) securing the submerged pump assembly complete with level gauge using the tool (1b).

	Description	Code
1b	Spanner	1.870.736.000

2. Remove the submerged fuel assembly complete with level gauge control.Remove the O-ring.

Refitting ( Removing

) 1. Place the O-Ring seal in the housing on the fuel tank collar and make sure that it is correctly positioned.

1. Position the submerged pump assembly complete with level gauge control in its housing.

Fit the submerged pump assembly complete with level gauge ensuring that the arrow is in line with the arrow on the tank.

2. Tighten the ring nut (2a) securing the submerged pump assembly complete with level gauge using the tool (2b).

	Description	Code
2b	Spanner	1.870.736.000

Connect the rapid connector for the fuel supply pipe to the submereged pump assembly complete with level gauge.Place the reinforcement plate back in its housing and secure it using the nuts and bolts.Connect the electrical connection to the submerged pump assembly complete with level gauge.Place the access cover to the submerged pump assembly complete with level gauge back in its housing and secure it using the bolts.Proceed with the refitting Op. 7050A22 REAR SEAT CUSHION - R+R.Proceed with the refitting Op. 7050A15 SPLIT REAR SEAT RIGHT SQUAB R R.Proceed with the refitting Op. 7050A13 SPLIT REAR SEAT LEFT SQUAB R R.Proceed with the refitting Op. 7040B10 LOAD PLATFORM (LUGGAGE PLATFORM) TRIM - R+R.Proceed with the refitting Op. 7040H80 PARCEL RACK.Connect the negative battery terminal (-).