125001151 - 1084A42 ENGINE OIL TEMPERATURE SENDER UNIT - R + R

Removing ( Refitting ) Position the vehicle on a lift.Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Description	Connector
-	Battery	See A1B BATTERY ( BATTERY NEGATIVE )

Proceed with the removal    Op. 7055B54 UNDER-ENGINE GUARD - R R.Proceed with the removal    Op. 1076B18 RIGID SECTION OF EXHAUST PIPE BETWEEN CATALYTIC CONVERTER AND SILENCER - R + R.1. Unscrew bolts (1a) and remove modular intake manifold bracket (1b) after releasing the electrical wiring from the fastenings. 1. Disconnect the electrical connection from the engine oil pressure warning light switch.

	Description	Connector
1	Engine oil pressure sensor (switch)	See K30 ENGINE OIL PRESSURE SENSOR SWITCH ( CONNECTORS )

2. Undo and remove the engine oil pressure warning light switch. Refitting ( Removing ) Place the engine oil pressure warning light switch in its housing and tighten it to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	-	INSUFFICIENT ENGINE OIL PRESSURE SWITCH	M14	(Engine crankcase side) 2.7 - 3.3

Connect the electrical connection to the engine oil pressure warning light switch.Refit the modular intake manifold bracket, secure with bolts and secure the electrical wiring to the bands.Proceed with the refitting    Op. 1076B18 RIGID SECTION OF EXHAUST PIPE BETWEEN CATALYTIC CONVERTER AND SILENCER - R + R.Proceed with the refitting    Op. 7055B54 UNDER-ENGINE GUARD - R R.Connect the negative battery terminal (-).Remove the vehicle from the lift.