125001227 - 1820B40 HOSE FROM CLUTCH RESERVOIR TO MASTER CYLINDER (PUMP) - R + R

Removing ( Refitting ) Proceed with the removal    Op. 1048A59 PIPE from flow meter to throttle casing hose - R.R..Proceed with the removal    Op. 5530B10 BATTERY - R+R.Proceed with the removal    Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R..1. Move the protective cover away.2. Remove the cap from the bleed valve.3. Connect the recovery device (pipe and reservoir) to the bleed valve on the clutch hydraulic actuator.4. Raise the retaining clip (4a) until the first click is heard and remove pipe (4b) by a sufficient amount to uncover the bleed hole.Leave the hydraulic clutch system to drain completely. 1. Loosen the band and disconnect the flexible pipe from the clutch reservoir to the master cylinder, reservoir side. 1. Loosen the band, disconnect the flexible pipe from the clutch reservoir to the master cylinder, master cylinder side and remove it. Refitting ( Removing ) Place the flexible pipe from the clutch reservoir to the master cylinder back in its housing and tighten the bands.Proceed with the refitting    Op. 0010T64 BRAKE AND OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY.Proceed with the refitting    Op. 0010T67 HYDRAULIC CLUTCH SYSTEM BLEED AIR.Proceed with the refitting    Op. 0010T65 HYDRAULIC BRAKE SYSTEM BLEED AIR.Proceed with the refitting    Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R..Proceed with the refitting    Op. 5530B10 BATTERY - R+R.Proceed with the refitting    Op. 1048A59 PIPE from flow meter to throttle casing hose - R.R..