125001230 - 1820B59 SMORZATORE DI VIBRAZIONI CIRCUITO IDRAULICO FRIZIONE CON TUBAZIONI ENTRATA E USCITA - S.R.

Removing ( Refitting ) Proceed with the removal    Op. 1048A59 PIPE from flow meter to throttle casing hose - R.R..Proceed with the removal    Op. 5530B10 BATTERY - R+R.Proceed with the removal    Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R..1. Move the protective cover away.2. Remove the cap from the bleed valve.3. Connect the recovery device (pipe and reservoir) to the bleed valve on the clutch hydraulic actuator.4. Raise the retaining clip (4a) until the first click is heard and remove pipe (4b) by a sufficient amount to uncover the bleed hole.Leave the hydraulic clutch system to drain completely. Lift up the clip completely and disconnect the pipe from the clutch hydraulic actuator.1. Lift up the retaining clip (1a) and disconnect the pipe (1b) from the clutch master cylinder. 1. Remove the clutch hydraulic circuit vibration damper and inlet and outlet pipes. Refitting ( Removing ) Place the clutch hydraulic circuit vibration damper and inlet and outlet pipes back in the housing.Fit the pipe fully home in its seat on the clutch master cylinder and secure with the retaining clip.Fit the pipe fully home in its seat on the hydraulic clutch actuator and secure with the retaining clip.Proceed with the refitting    Op. 0010T64 BRAKE AND OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY.Proceed with the refitting    Op. 0010T67 HYDRAULIC CLUTCH SYSTEM BLEED AIR.Proceed with the refitting    Op. 0010T65 HYDRAULIC BRAKE SYSTEM BLEED AIR.Proceed with the refitting    Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R..Proceed with the refitting    Op. 5530B10 BATTERY - R+R.Proceed with the refitting    Op. 1048A59 PIPE from flow meter to throttle casing hose - R.R..