3330B24 BRAKE PEDAL - R R FOR VERSIONS WITH MANUAL GEARBOX WITH HYDRAULIC SELECTION (SMART GEARBOX) - Alfa - GT - eLearn

125001344 - 3330B24 BRAKE PEDAL - R R FOR VERSIONS WITH MANUAL GEARBOX WITH HYDRAULIC SELECTION (Smart gearbox)

Removing ( Refitting

)

Undo the nuts (1a) and remove the protection (1b).

Working at the rear of the brake pedal, press the white retaining tabs (1a) securing the brake servo push rod (1b) to the brake pedal (1c).

Remove the black retaining device (1a), then release the brake servo push rod (1b) from the brake pedal (1c) and keep the brake servo push rod spherical head housing cover (1d).

After every dismantling operation, the black retaining device for the brake servo push rod (1a) must be removed even if it appears to be intact.

Remove the clip (1a) and partly release the pin (1b).
Remove the brake pedal (2a) and bushes (2b).

Refitting ( Removing

)

Place the brake pedal in its housing, then secure it using the pin and the clip.

Fit the new retaining device (1a) on the brake pedal (1b) so that the fastening clips (1c) are secured; position the brake servo push rod spherical head housing cover (1d).

After each dismantling operation, the black coloured retaining device for the brake servo push rod must always be replaced even if it appears to be intact.

Lift up the brake pedal and position the brake servo push rod by the retaining device.
Press the brake pedal to fit the brake servo push rod on the retaining device.
Fit the protection in its housing and secure it using the nuts.