125002037 - 7210E44 R.R. UNDERDOOR SIDE MEMBER OUTER TRIM/

Removing ( Refitting ) Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).Straighten the body if necessary.
1. Remove the PVC treatment from the door sill to expose the weld spots using a vibrating cutter and appropriate blade.2. Use a rotary brush to clean the panel edges to reveal the weld spots.
1. Use a chamfering machine to crop the weld spots indicated in the figure.2. Use a drill fitted with an appropriate bit to drill out the weld spots in the areas shown in the figure.Open the door sill fastenings.3. Use a circular saw to follow the cutting lines shown in the enlargements and in the figure.Use a chisel and hammer to remove spots ground previously.4. Remove the door sill from the car.
1. Straighten the door sill compartment flaps using a mallet and profiled stake.Use a grinding wheel to remove the weld spot residues.Use a rotary brush to clean the treated areas.Apply the electric weld paint finish.
Refitting ( Removing ) 1. Fit the part in its seat after thoroughly degreasing and secure using self-locking grippers.2. Refit the front door.Check alignment and ensure the surrounding gap is even, then remove the door.
1. Use a circular saw to lay part (1) over the front pillar (1a) and the door sill end section (1c).Trim the cut edges and remove the part.
1. Use a rotary brush to remove the corrosion-proof treatment from around the inner and outer edges of the part.2. Drill out equidistant holes along the lower and side edges of the part.Apply electric weld paint finish to the eges in contact with the car.
Position the part on the car and secure using self-locking clips.1. Use a spot welder to weld the areas shown in the figure.2. Use a MIG welder to weld the ends and fill the holes made previously.
Correct any deformations in the panel using a profiled stake and mallet.Crimp the reference tabs.1. Use a grinding wheel to level the weld and remove.Use a rotary brush to clean the newly-welded areas.
1. Apply rust-proofing to newly-welded areas.2. Seal the joint lines between the part and the car.Apply paint.3. Apply wax oil inside the door sill.