1056F94 SYSTEM CABLE LOOM ON ENGINE - R.R. - Alfa - GT - eLearn

2923170 - 1056F94 SYSTEM CABLE LOOM on ENGINE - R.R.

) Position the vehicle on the ramp Proceed with removal - 1016A40 ignition coil cover on cylinder head- r+r Proceed with removal - 1048A59 PIPE from flow meter to throttle casing hose - R.R. Proceed with removal - 5530B10 battery - r+r 1. Disconnect the electrical connection from the throttle body with D.V.L. and release the wiring from the fastening.

	Name	Connector
1	Throttle body actuator	N75

1. Disconnect the electrical connection from the fuel pressure regulator.

	Name	Connector
1	Fuel pressure regulator	N77

2. Disconnect the electrical connection from the fuel pressure sensor.

	Name	Connector
2	Fuel pressure sensor	K83

1. Disconnect the electrical connection from the engine coolant temperature sensor.

	Name	Connector
1	Engine temperature sender unit	K36

1. Disconnect the electrical connection of the coil wiring loom and release it from the fixing bracket.

1. Disconnect the electrical connection from the variable valve timing electro-magnet.

	Name	Connector
1	Timing variator actuator	N76

2. Disconnect the electrical connection from the enablement solenoid of the changeover device actuator.

	Name	Connector
2	Variable geometry control solenoid	L15

3. Disconnect the electrical connection for the cam angle sensor.

	Name	Connector
3	Timing sensor.	K47

1. Undo the bolt (1a) and disconnect the earth lead (1b) from the cam cover.2. Disconnect the electrical connections from the ignition coils.

	Name	Connector
2	Ignition coil	A30

3. Disconnect the electrical connection for the air conditioning compressor electromagnet coupling.

	Name	Connector
3	Air conditioning compressor engagement electro-magnet	L20

4. Undo the bolts securing the coil wiring loom to the tappet cover.

1. Remove the coil wiring loom.

Refitting ( Removing

) Refit the coil wiring loom in its seating and secure it with its bolts.Connect the electrical connection to the air conditioning compressor electromagnet coupling.Connect the electrical connections to the ignition coils.Connect the earth lead to the tappet cover and secure it with its bolt.Connect the electrical connection for the cam angle sensor.Connect the electrical connection from the enablement solenoid of the changeover device actuator.Connect the electrical connection to the variable valve timing electro-magnet.Connect the electrical connection for the coil wiring loom, and secure it to the mounting bracket.Connect the electrical connection to the engine coolant temperature sensor. Connect the electrical connection to the fuel pressure senor.Connect the electrical connection to the fuel pressure regulator.Connect the electrical connection to the throttle body with D.V.L. and release the electrical wiring from the band. Proceed with refitting - 5530B10 battery - r+r . Proceed with refitting - 1048A59 PIPE from flow meter to throttle casing hose - R.R. . Proceed with refitting - 1016A40 ignition coil cover on cylinder head- r+r . Remove the car from the ramps.