B20 ENGINE STARTS, AND CUTS OUT STRAIGHT AWAY - Alfa - GT - eLearn

The engine starts normally, though possibly with difficulty, then suddenly stalls

1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
		Results of the tests
	Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket and check the following at the engine control node: That there are no errors in the control unit; Parameter plausibility	Move on to Step 2 1	Error detected in the control unit	Proceed as instructed by the diagnostic tester
		Move on to Step 2 1	Parameters not plausible	Proceed as instructed by the diagnostic tester
2	SUPPLY PRESSURE CHECK	All OK	Problems encountered	Operation
	Check the fuel supply pressure with the ignition ON and the engine switched off Op. Op. 0510C10 FUEL SYSTEM - CHECK DELIVERY PRESSURE.Start the engine and check that the supply pressure does not decrease	Move on to Step 3 1	The supply pressure decreases	Replace the fuel pump assembly Op. Op. 1040A70 SUBMERGED PUMP ASSEMBLY COMPLETE WITH LEVEL GUAGE CONTROL - R + R
3	CHECK ON CORRECT OPERATION	All OK	Problems encountered	Operation
	Check that the fault is no longer present	End of diagnosis	Fault persists: engine management control unit defective	Replace the engine management control unit Op. 1056B82