K48 I.E. FAILURE WARNING LIGHT FLASHING - Alfa - GT - eLearn

The MIL failure warning light flashes when the engine has been started

The warning light can flash in two different ways: with the vehicle started up and stationary or with the vehicle driving.

1	CHECK ON FUEL RESERVE WARNING LIGHT	All OK	Problems met	Operation
		Results of the tests
	Check that the fuel reserve warning light is off	Continue to Step 2	Fuel reserve warning light on	Make sure the fuel level is above the reserve areaContinue to Step 4
2	FUEL LEVEL CHECK	All OK	Problems met	Operation
	Check that the fuel gauge is working properly	Continue to Step 3	Fuel gauge not working	Continue according to the instructions inSee table See table K20 FUEL LEVEL GAUGE NOT WORKING
3	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the diagnostic equipment (Examiner or Examiner Plus) and check that the Misfire error is not present	End of diagnosis	Misfire error present	Continue according to the instructions inSee table See table Z53 MISFIRE ERROR
4	ERROR CANCELLING AND CHECKING	All OK	Problems met	Operation
	Use a tester to cancel the errors in the control unit.Carry out a road test and ensure the error does not recur.	Continue to Step 5	Misfire error present	Continue according to the instructions inSee table See table Z53 MISFIRE ERROR
5	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	.