125000675 - P15 LUGGAGE COMPARTMENT DOES NOT OPEN WITH REMOTE CONTROL

When opening is controlled by means of the remote control unit, the boot lid does not open.

The boot lid opening command is received by the Body Computer Node via the internal radio aerial; the Body Computer Node releases the boot lock and releases is slightly, thus disabling the alarm (if present).When the door lock is disengaged, the boot lid opens to operate the electric handle on the bonnet.

In ''independent boot'' mode, boot lid opening is implemented by means of a remote control unit or dowel on the mechnical key.

		Results of the tests
1	PRELIMINARY CHECKS	All OK	Problems met	Operation
	Check the correct operation using the key and the button in the dashboard.Check the remote control battery charge	Continue to Step 2	The opening of the boot does not work with either the key or via the dashboard	Continue according to the instructions inSee table    See table P14 BOOT OPENING/CLOSING NOT WORKING
			Battery not working properly	Replace the battery
2	REMOTE CONTROL CHECK	All OK	Problems met	Operation
	Check the operation of the system using the second remote control unit supplied with the car.	Continue to Step 3	The fault persists	Continue to Step 4
3	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the diagnostic equipment (Examiner) and check the defective remote control unit correctly stored in the Body Computer Node configuration.	Continue to Step 9	Remote control unit not stored in the Body Computer Node configuration.	Programme the remote control
4	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the Examiner and ensure the remote control units are stored in the Body Computer Node configuration.	Continue to Step 5	Remote control units not stored in Body Computer Node configuration.	Programme the remote controls
5	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Keep the Examiner connected and check individual remote control keys are properly downloaded and operational while in parameter mode.	Continue to Step 8	Remote control unit signals have not been properly downloaded.	Continue to Step 6
6	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Use an Examiner to check for errors.	Continue to Step 8	Error found: radio receiver faulty	Continue to Step 7
7	ELECTRICAL CIRCUIT CHECK	All OK	Problems met	Operation
	Check the RF receiver aerial.	Continue to Step 8	Connect the incorrectly connected aerial to the radio receiver	Connect the aerial connector correctly to the Body Computer Node.
			Radio receiver aerial broken	Replace the RF receiver aerial Op.    Op. 5570T61 MULTI-FUNCTION AERIAL - R R
8	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present.	End of diagnosis	The fault persists	Replace the body computer node Op.    Op. 5505A32 BODY COMPUTER - R R
9	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present.	End of diagnosis	The fault persists	Change the remote control unit