125000677 - P30 DOORS / BOOT OPEN BUZZER NOT PRESENT WITH CAR IN MOTION

With the vehicle moving, the accidental opening of one of the doors or the boot is not indicated by the buzzer.
The instrument panel node acquires from the network the signal indicating the status of the door switches or boot and the vehicle speed. If a door or the boot are opened and the vehicle speed is over 4 km/h, an acoustic signal is emitted.Warning: This function can be enabled/disabled via the MODE +/- keys on the controls switch panel unit. Make sure that the function has not been disabled incorrectly by the user
Results of the tests
0PRELIMINARY CHECKSAll OKProblems metOperation
Connect the Examiner diagnostic instrument and check, in the active diagnosis environment, that the buzzer is working properlyContinue to Step 1The buzzer is not workingReplace the Instrument Panel Node Op.    Op. 5560B11 ANALOGUE CONTROL PANEL - R+R OR REPLACE
1CHECKING WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation
Connect an Examiner and check the door/boot status has been correctly downloaded while in parameter modeContinue to Step 4Malfunction in downloading door switch statusContinue to Step 2
Malfunction in downloading boot open switch statusContinue to Step 3
2ELECTRICAL CONNECTIONS CHECKAll OKProblems metOperation
Check the electrical connections between the doors and Body Computer See    See E2510 COURTESY LIGHTSAlso check that the door switches are not faultyContinue to Step 4Connections faultyRestore the correct connections See    See E2510 COURTESY LIGHTS
Door switch faultyReplace the door open motor Op.    Op. 7005N21 FRONT SIDE DOOR LOCK MOTOR-LOCK ASSEMBLEY-R R
3ELECTRICAL CONNECTIONS CHECKAll OKProblems metOperation
Check the electrical connections between boot open switch and Body Computer See    See E2520 GLOVE COMPARTMENT LIGHT - LUGGAGE COMPARTMENT LIGHT - SUN VISOR LIGHTAlso check that the boot open switch is not faultyContinue to Step 4Connections faultyRestore the correct connections See    See E2520 GLOVE COMPARTMENT LIGHT - LUGGAGE COMPARTMENT LIGHT - SUN VISOR LIGHT
Boot open switch faultyReplace the boot outer handle Op.    Op. 7015B70 TAIL-GATE LOCK MOTOR - R R AND CHECK LOCK SUPPLY LINE
4CHECK WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation

Connect the Examiner and check on the body computer node:

  • that there are no errors on the C-CAN line;
  • that there are no errors for the speedometer signal.
Continue to Step 5Error in the C-CAN line.Continue following the instructions for the diagnostic equipment
Error found in speedometer signal.Continue according to the instructions inSee table    See table K03 SPEEDOMETER NOT WORKING
5CHECK WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation

Keep the Examiner connected and check the body computer node for:

  • that there are no errors on the B-CAN line;
  • that there are no errors for the speedometer signal.
Continue to Step 6Error found in the B-CAN line.Continue following the instructions for the diagnostic equipment
Error found in speedometer signal.Continue according to the instructions inSee table    See table K03 SPEEDOMETER NOT WORKING
6ELECTRICAL CONNECTIONS CHECKAll OKProblems metOperation
Check the electrical connections between the instrument panel and Body Computer See    See E4010 INSTRUMENT PANELContinue to Step 7Connections faultyRestore the correct connections See    See E4010 INSTRUMENT PANEL
7CHECK ON CORRECT OPERATIONAll OKProblems metOperation
End of diagnosisThe fault persistsReplace the Body Computer Op.    Op. 5505A32 BODY COMPUTER - R R