125001409 - 4130B20 POWER STEERING PUMP R R

Removing ( Refitting ) Position the vehicle on the rampEnsure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	See A1B BATTERY ( BATTERY NEGATIVE )

Drain the power steering fluid from the reservoir using a suitable syringe.Proceed with removal    Op. 4450B04 RIGHT FRONT WHEEL R RProceed with removalProceed with removal    Op. 7055B64 LH OR RH REFLECTOR(ONE) ON REAR BUMPERS - R RProceed with removalProceed with removal    Op. 1092G10 SINGLE ENGINE BELT R RProceed with removal1. Undo the connector (1a) and disconnect the delivery pipe from pump to power steering box (1b), pump side.    Op. 7055B54 UNDER-ENGINE GUARD - R R2. Undo the connector (2a) and disconnect the power steeing intake pipe from the fluid reservoir pipe (2b), power steering pump side.3. Undo bolts (3a) and remove power steering pump (3b)    Op. 1080B92 LEFT UPPER LAMBDA SENSOR R R    Op. 1076A70 HEAT SHIELD FOR LEFT CATALYTIC PRECONVERTER R R Refitting ( Removing ) 1. Refit the power steering pump (1a) in its seating and tighten its bolts (1b) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	POWER STEERING PUMP	M8	(Support side) 2.3 ÷ 2.8

2. Connect the power steering pump intake pipe from the the power steering reservoir (2a), power steering pump side and tighten the connector (2b) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
2b	-	-	-	-

3. Connect the supply pipe from the power assisted steering pump (3a), power steering pump side and tighten the connector (3b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
3b	Connector	PIPE BTWN PUMP + POWER STEERING BOX	M16	(Power assisted steering pump side) 4.6 ÷ 5.5

Proceed with refitting    Op. 1076A70 HEAT SHIELD FOR LEFT CATALYTIC PRECONVERTER R R.Proceed with refitting    Op. 1080B92 LEFT UPPER LAMBDA SENSOR R R.Proceed with refitting    Op. 7055B54 UNDER-ENGINE GUARD - R R.Proceed with refitting    Op. 1092G10 SINGLE ENGINE BELT R R.Proceed with refitting    Op. 7055B64 LH OR RH REFLECTOR(ONE) ON REAR BUMPERS - R R.Proceed with refitting    Op. 4450B04 RIGHT FRONT WHEEL R R.Connect the negative (-) battery terminalFill the power steering circuit with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid [l]	HYDRAULIC POWER ASSISTED STEERING SYSTEM	TUTELA GI/A	1.2

The table shows the total quantity of fluid present in the power assisted steering circuit.

Bleed the power steering system as described belowWith the front wheels raised off the ground, with the engine switched off turn the steering wheel to full lock, left and right, 4-5 times.Check and, if necessary, top up the fluid level in the reservoir.Remove the car from the ramps.Start the engine and carry out 4 - 5 full steering wheel turn cycles (right and left).Top up the fluid level in the reservoir.