125000914 - 1016E38 SINGLE CYLINDER HEAD OR (ONE) L OR R, REMOVED - GRINDING

Clean the residues of the old gasket from the lower surface of the cylinder head.1. The table gives the lower cylinder head surface planarity value.

	Measurement		Value
1	Cylinder head lower plane planarity (mm)		< 0.1

1. Reface the lower cylinder head surface without exceeding the minimum permitted height.

If necessary, both cylinder heads should be refaced.

The minimum permitted cylinder head height should never be exceeded, or else the actual cylinder head has to be replaced.

	Measurement		Value
1	Minimum permitted cylinder head height (mm)		134.85 ÷ 135.15