125000926 - 1020D18 FRONT CRANK SHAFT COVER OIL SEAL - REPLACE

Removing ( Refitting ) Position the vehicle on a lift.Proceed with the removal    Op. 4450B04 RIGHT FRONT WHEEL R R.Proceed with the removal    Op. 7055B64 LH OR RH REFLECTOR(ONE) ON REAR BUMPERS - R R.Proceed with the removal    Op. 1092G10 SINGLE ENGINE BELT R R.Proceed with the removal    Op. 1092A10 CRANKSHAFT SERVICES PULLEY - R.R..Proceed with the removal    Op. 1032D12 TIMING SYSTEM PROTECTIVE COVER(S) - R + R.Proceed with the removal    Op. 1016A42 LEFT HAND CYLINDER HEAD IGNITION COIL COVER - R+R.Proceed with the removal    Op. 5510C16 LEFT HAND CYLINDER HEAD IGNITION COIL - R+R.Proceed with the removal    Op. 1016A30 LEFT CAM COVER - R + R AND REPLACE GASKET.Proceed with the removal    Op. 1072B50 SLEEVES CONNECTING AIR CAPACITY BOX TO INLET MANIFOLD IS - R+R.Proceed with the removal    Op. 5510C18 RIGHT HAND CYLINDER HEAD IGNITION COIL - R+R.Proceed with the removal    Op. 1016A34 RIGHT-HAND CAM COVER - R + R AND REPLACE GASKET.Proceed with the removal    Op. 1032B10 TOOTHED TIMING BELT - R + R FOR TIMING ADJUSTMENT OR REPLACEMENT.1. Remove the toothed drive pulley2. Remove the spacer.
1. Remove the crankshaft key using a suitable drift.2. Release and remove the crankshaft front oil seal cover.
Take care not to damage the oil seal seat during its removal.The oil seal is ruined during the removal operation so it must always be replaced.
Refitting ( Removing ) 1. Fit a new the crankshaft front cover oil seal (1a) in the housing using the tool (1b).
DescriptionCode
1bFitting tool1.860.949.000
Place the key in the housing in the crankshaft.Place the spacer back in its housing.Place the toothed drive pulley in its housing.Proceed with the refitting    Op. 1032B10 TOOTHED TIMING BELT - R + R FOR TIMING ADJUSTMENT OR REPLACEMENT.Proceed with the refitting    Op. 1016A34 RIGHT-HAND CAM COVER - R + R AND REPLACE GASKET.Proceed with the refitting    Op. 5510C18 RIGHT HAND CYLINDER HEAD IGNITION COIL - R+R.Proceed with the refitting    Op. 1072B50 SLEEVES CONNECTING AIR CAPACITY BOX TO INLET MANIFOLD IS - R+R.Proceed with the refitting    Op. 1016A30 LEFT CAM COVER - R + R AND REPLACE GASKET.Proceed with the refitting    Op. 5510C16 LEFT HAND CYLINDER HEAD IGNITION COIL - R+R.Proceed with the refitting    Op. 1016A42 LEFT HAND CYLINDER HEAD IGNITION COIL COVER - R+R.Proceed with the refitting    Op. 1032D12 TIMING SYSTEM PROTECTIVE COVER(S) - R + R.Proceed with the refitting    Op. 1092A10 CRANKSHAFT SERVICES PULLEY - R.R..Proceed with the refitting    Op. 1092G10 SINGLE ENGINE BELT R R.Proceed with the refitting    Op. 7055B64 LH OR RH REFLECTOR(ONE) ON REAR BUMPERS - R R.Proceed with the refitting    Op. 4450B04 RIGHT FRONT WHEEL R R.Remove the vehicle from the lift.