1040A30 OIL SEAL COVER, FLY WHEEL SIDE - R + R AND REPLACE SEALS - Alfa - GT - eLearn

125001002 - 1040A30 OIL SEAL COVER, FLY WHEEL SIDE - R + R AND REPLACE SEALS

) Position the vehicle on a lift.Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal.

	Description	Connector
-	Battery	See A1B BATTERY ( BATTERY NEGATIVE )

Proceed with the removal Op. 4450B08 RIGHT REAR WHEEL R R.Proceed with the removal Op. 7055B45 RIGHT HAND REAR SUPPLEMENTARY WHEEL ARCH - R+R.Proceed with the removal Op. 1040A70 SUBMERGED PUMP ASSEMBLY COMPLETE WITH LEVEL GUAGE CONTROL - R + R.Draw off the fuel from the tank using a special tool.1. Undo the bolts (1a) and disconnect the fuel filler pipe assembly (1b) from the bodyshell.

1. Position a hydraulic jack under the rear suspension crossmember.2. Undo the bolts (2a) and lower the rear suspension crossmember (2b) as far as necessary using the hydraulic jack.

1. Remove the two fuel filler pipe protection clips.

1. Open the band and disconnect the fuel filler pipe from the tank.2. Loosen the band and disconnect the fuel reflux pipe from the tank.3. Disconnect the rapid connectors for the fuel vapour supply pipes from the float valves to the fuel vapour separator.4. Disconnect the rapid connector for the fuel vapour supply pipe from the multifunction valve to the fuel vapour filter.

1. Remove the fuel filler pipe assembly.

Refitting ( Removing

) Place the fuel filler pipe assembly in its housing.Connect the rapid connector for the fuel vapour supply pipe from the multifunction valve to the fuel vapour filter.Connect the rapid connectors for the fuel vapour supply pipes from the float valves to the fuel vapour separator.Connect the fuel reflux pipe to the tank and secure it using the band.Connect the fuel filler pipe to the tank and secure it using the band.Place the two fuel filler pipe protection clips in position.Place the rear suspension crossmember in position using the hydraulic jack and secure it tightening the bolts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR CROSS-BEAM	M10	(Bodyshell side) 5.8 - 7.2

Remove the hydraulic jack from underneath the rear suspension crossmember.Tighten the bolts fixing the fuel filler pipe.Proceed with the refitting Op. 1040A70 SUBMERGED PUMP ASSEMBLY COMPLETE WITH LEVEL GUAGE CONTROL - R + R.Proceed with the refitting Op. 7055B45 RIGHT HAND REAR SUPPLEMENTARY WHEEL ARCH - R+R.Proceed with the refitting Op. 4450B08 RIGHT REAR WHEEL R R.Connect the negative battery terminal (-).Remove the vehicle from the lift.