125001005 - 1040A70 SUBMERGED PUMP ASSEMBLY COMPLETE WITH LEVEL GUAGE CONTROL - R + R

When scrapping the submerged pump assembly with level gauge mechanism, always empty of fuel as follows:

    Removing ( Refitting ) Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal.
    DescriptionConnector
    -Battery See A1B BATTERY ( BATTERY NEGATIVE )
    Proceed with the removal    Op. 7040H80 PARCEL RACK.Proceed with the removal    Op. 7040B10 LOAD PLATFORM (LUGGAGE PLATFORM) TRIM - R+R.Proceed with the removal    Op. 7050A13 SPLIT REAR SEAT LEFT SQUAB R R.Proceed with the removal    Op. 7050A15 SPLIT REAR SEAT RIGHT SQUAB R R.Proceed with the removal    Op. 7050A22 REAR SEAT CUSHION - R+R.1. Undo the bolts (1a) and move the access cover (1b) for the submerged pump assembly complete with level gauge sideways.
    1. Disconnect the electrical connection from the submerged pump assembly complete with level gauge.
    DescriptionConnector
    1Fuel pump and level gauge See N40 FUEL PUMP AND SENDER UNIT
    2. Undo the bolts (2a) and the nuts (2b) and remove the reinforcement plate (2c).3. Disconnect the rapid connector for the fuel supply pipe from the submereged pump assembly complete with level gauge.
    1. Undo the ring nut (1a) securing the submerged pump assembly complete with level gauge using the tool (1b).
    DescriptionCode
    1bSpanner1.870.736.000
    2. Remove the submerged fuel assembly complete with level gauge control.Remove the O-ring.
    Refitting ( Removing ) 1. Place the O-Ring seal in the housing on the fuel tank collar and make sure that it is correctly positioned.
    1. Position the submerged pump assembly complete with level gauge control in its housing.
    Fit the submerged pump assembly complete with level gauge ensuring that the arrow is in line with the arrow on the tank.
    2. Tighten the ring nut (2a) securing the submerged pump assembly complete with level gauge using the tool (2b).
    DescriptionCode
    2bSpanner1.870.736.000
    Connect the rapid connector for the fuel supply pipe to the submereged pump assembly complete with level gauge.Place the reinforcement plate back in its housing and secure it using the nuts and bolts.Connect the electrical connection to the submerged pump assembly complete with level gauge.Place the access cover to the submerged pump assembly complete with level gauge back in its housing and secure it using the bolts.Proceed with the refitting    Op. 7050A22 REAR SEAT CUSHION - R+R.Proceed with the refitting    Op. 7050A15 SPLIT REAR SEAT RIGHT SQUAB R R.Proceed with the refitting    Op. 7050A13 SPLIT REAR SEAT LEFT SQUAB R R.Proceed with the refitting    Op. 7040B10 LOAD PLATFORM (LUGGAGE PLATFORM) TRIM - R+R.Proceed with the refitting    Op. 7040H80 PARCEL RACK.Connect the negative battery terminal (-).