1820B30 SLAVE CYLINDER - R + R - Alfa - GT - eLearn

125001225 - 1820B30 SLAVE CYLINDER - R + R

) Proceed with the removal Op. 5530B10 BATTERY - R+R.Proceed with the removal Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R..Remove the protective cap from the bleed valve on the clutch operating cylinder.Connect the recovery device (pipe and reservoir) to the bleed valve on the clutch operating cylinder.Operate the clutch pedal until the brake/clutch reservoir is drained.1. Undo the connector (1a) and disconnect the pipe from the vibration damper to the operating cylinder (1b), operating cylinder side.2. Remove the circlip (2a) and release the operating cylinder (2b) from the mounting.

1. Undo the bolts (1a) and remove the operating cylinder mounting (1b).

Refitting ( Removing

) Place the operating cylinder mounting in its housing and secure it using the bolts.1. Place the operating cylinder (1a) in its housing and secure it to the mounting using the circlip (1b).2. Connect the pipe from the vibration damper to the operating cylinder (2a), operating cylinder side and tighten the connector (2b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
2b	-	-	-	-

Bleed the air and top up the clutch release hydraulic system fluid level. Op. 0010T67 HYDRAULIC CLUTCH SYSTEM BLEED AIR.Bleed the air from the hydraulic braking system Op. 0010T65 HYDRAULIC BRAKE SYSTEM BLEED AIR.Proceed with the refitting Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R..Proceed with the refitting Op. 5530B10 BATTERY - R+R.