3310A30 FRONT BRAKE CALIPER ONE R R - Alfa - GT - eLearn

125001312 - 3310A30 FRONT BRAKE CALIPER ONE R R

) Position the vehicle on the rampEnsure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	See A1B BATTERY ( BATTERY NEGATIVE )

Proceed with removal Op. 4450B02 LEFT FRONT WHEEL R RRemove the protective cap on the brake caliper bleed valve.Connect the collection system (pipe and reservoir) to the bleed valve on the brake caliper.Operate the brake pedal until the brake-clutch reservoir and pipes are empty.1. Undo the connectors (1a) and remove the rigid pipe to the brake caliper (1b).2. Disconnect the electrical connections for the brake pad wear cable.3. Undo the bolts (3a) and remove the front brake caliper (3b) complete with brake pads.

	Name	Connector
2	Left brake pad wear sensor switch	See K20 LEFT BRAKE PAD WEAR SENSOR SWITCH ( FRONT )

Refitting ( Removing

) 1. Refit the rear brake caliper assembly (1a) complete with pads and tighten the bolts (1b) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	FRONT BRAKE CALIPER ASSEMBLY	M12

2. Connect the electrical connection for the brake pad wear cable.3. Refit the rigid pipe to the brake caliper (3a) in its seating and tighten the connectors (3b) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
3b	Connector	FITTING FOR PIPE TO CALIPER	M10	(Brake caliper side) 1.4 ÷1.8

	Fastening	Component	Ø	Value(daNm)
3b	Connector	FITTING FOR PIPE TO CALIPER	M10	(Flexible pipe side) 1.4 ÷ 1.8

Top up the brake-clutch fluid level Op. 0010T64 BRAKE AND OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY.Bleed the air from the hydraulic braking system Op. 0010T65 HYDRAULIC BRAKE SYSTEM BLEED AIR.Proceed with refitting Op. 4450B02 LEFT FRONT WHEEL R R.Connect the negative (-) battery terminalRemove the car from the ramps.