4130B36 SUPPLY PIPE FROM FLUID RESEVIOR TO POWER STEERING PUMP INLET PIPE R R - Alfa - GT - eLearn

125001413 - 4130B36 SUPPLY PIPE FROM FLUID RESEVIOR TO POWER STEERING PUMP INLET PIPE R R

) Position the vehicle on the rampProceed with removal Op. 7055B54 UNDER-ENGINE GUARD - R RProceed with removalProceed with removal Op. 1076B82 LEFT EXHASUST PIPE BETWEEN CATALYTIC PRECONVERTER AND CONVERTER R RDrain the power steering fluid from the reservoir using a suitable syringe.1. Undo the bolts (1a) and raise the power steering fluid reservoir (1b) as much as necessary. Op. 1076B84 RIGHT EXHAUST PIPE BETWEEN CARALYTIC PRECONVERTER AND CONVERTER R R2. Loosen the band (2a) and disconnect the supply hose from the fluid reservoir from the power assisted steering pump inlet pipe (2b), reservoir side.

1. Undo the bolts (1a) and remove the underbody reinforcements (1b).2. Undo the bolts securing the power steering box to the front suspension crossmember.

1. Undo the bolt (1a) and remove the bracket (1b) fixing the power steering pipes.Move the power steering box as much as necessary and undo the nut securing the rigid section of the delivery hose from the fluid reservoir to the fluid reservoir to the rigid inlet pipe for the power steering pump to the power steering box.2. Disconnect the supply pipe from the reservoir to the power assisted steering pump inlet pipe, power steering pump inlet pipe side.

1. Release the delivery hose from the fluid reservoir to the power steering pump inlet pipe from the fastenings on the power steering box and remove.

Refitting ( Removing

) Refit the supply pipe from the coolant reservoir to the power assisted steering pump inlet pipe and secure to the power steering box.Connect the supply pipe from the fluid reservoir to the power assisted steering pump inlet pipe, power steering pump inlet pipe side.Tighten the nut securing the rigid section of the delivery hose from the fluid reservoir to the rigid inlet pipe for the power steering pump to the power steering box, then refit the power steering box in its seatRefit the power steering pipe lower mounting bracket in its seating and secure with the bolt.1. Tighten the bolts securing the power steering box to the front suspension crossmember to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1	Bolt	POWER STEERING BOX	M14	(Front suspension crossmember side) 11.7 ÷ 14.3

2. Refit the underbody reinforcements (2a) and secure with bolts (2b).

Connect the delivery hose from fluid reservoir to the power steering pump inlet pipe, reservoir side, and tighten the band.Refit in its seating the power steering fluid reservoir and secure it with its bolts.Proceed with refitting Op. 1076B84 RIGHT EXHAUST PIPE BETWEEN CARALYTIC PRECONVERTER AND CONVERTER R R.Proceed with refitting Op. 1076B82 LEFT EXHASUST PIPE BETWEEN CATALYTIC PRECONVERTER AND CONVERTER R R.Proceed with refitting Op. 7055B54 UNDER-ENGINE GUARD - R R.Fill the power steering circuit with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid [l]	HYDRAULIC POWER ASSISTED STEERING SYSTEM	TUTELA GI/A	1.2

The table shows the total quantity of fluid present in the power assisted steering circuit.

Bleed the power steering system as described belowWith the front wheels raised off the ground, with the engine switched off turn the steering wheel to full lock, left and right, 4-5 times.Check and, if necessary, top up the fluid level in the reservoir.Remove the car from the ramps.Start the engine and turn the steering wheel to full lock, left and right, 4 - 5 times.Top up the fluid level in the reservoir.