4130B38 POWER STEERING PUMP INLET PIPE FROM FLUID RESEVIOR PIPE OR INTERMEDIATE RIGID PIPE R R - Alfa - GT - eLearn

125001414 - 4130B38 POWER STEERING PUMP INLET PIPE FROM FLUID RESEVIOR PIPE OR INTERMEDIATE RIGID PIPE R R

) Position the vehicle on the rampDrain the power steering fluid from the reservoir using a suitable syringe.Proceed with removal Op. 7055B54 UNDER-ENGINE GUARD - R R1. Undo the nut (1a) and remove the front bracket (1b) supporting the power steering pipes.

1. Undo bolts (1a) and remove rear bracket (1b) supporting the power steering pipes.2. Disconnect the power steering pump inlet pipe from the fluid reservoir pipe, fluid reservoir pipe side.

1. Undo the connector (1a) and disconnect the power steering pump inlet pipe from the fluid reservoir pipe (1b), power steering pump side.

1. Remove the power steering pump inlet pipe from the fluid reservoir pipe, releasing from its rubber mounts.

Refitting ( Removing

) Refit the power steering pump inlet pipe from the fluid reservoir pipe by fastening to the rubber mounts.1. Connect the power steering pump inlet pipe from the fluid reservoir pipe (1a) power steering pump side and secure by tightening fitting (1b) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1b	-	-	-	-

Connect the power steering pump inlet pipe from the fluid reservoir pipe, fluid reservoir pipe side and tighten the band.Place the power assisted steering pipes rear mounting bracket back in its housing and secure with the bolt.Refit the front bracket supporting the engine oil/power steering pipes back in its seating and secure it with the nut.Proceed with refitting Op. 7055B54 UNDER-ENGINE GUARD - R R.Fill the power steering circuit with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid [l]	HYDRAULIC POWER ASSISTED STEERING SYSTEM	TUTELA GI/A	1.2

The table shows the total quantity of fluid present in the power assisted steering circuit.

Bleed the power steering system as described belowWith the front wheels raised off the ground, with the engine switched off turn the steering wheel to full lock, left and right, 4-5 times.Check and, if necessary, top up the fluid level in the reservoir.Remove the car from the ramps.Start the engine and turn the steering wheel to full lock, left and right, 4 - 5 times.Top up the fluid level in the reservoir.