125001937 - 7050A13 SPLIT REAR SEAT LEFT SQUAB R R

Removing ( Refitting )     Op. 7050A22 REAR SEAT CUSHION - R+RConnect the electrical connections.    Op. 7040H80 PARCEL RACK    Op. 7040B10 LOAD PLATFORM (LUGGAGE PLATFORM) TRIM - R+R1. Undo the bolt securing the squab to the floor.

Use HEXAGONAL SPLINED wrench No. 8 (USAG 234 or equivalent).

2. Undo the bolt fixing the backrest connecting pin. Lower the squab.1. Undo the middle nut (1a) and bolt (1b) fixing the backrest to the floor.2. Undo the side nut (2a) and bolt (2b) fixing the backrest to the floor.

Use HEXAGONAL SPLINED wrench No. 8 (USAG 234 or equivalent).

3. Remove the rear seat left backrest. Refitting ( Removing ) Check that the squab is not damaged.1. Position the squab.2. Tighten the middle nut (2a) and the side nut (2b) fixing the backrest to the floor.3. tighten the middle bolt (3a) and the side bolt (3b) fixing the backrest to the floor.

Use the bolts specified by the manufacturer because longer bolts could interfere with the fuel tank.

	Fastening	Component	Ø	Value(daNm)
2a	Nut	REAR SEAT BACKREST JOINTS.	M10 x 1.25	35

	Fastening	Component	Ø	Value(daNm)
3a	Bolt	REAR SEAT BACKREST JOINTS.	M10 x 1.25	35

Lift the squab.Tighten the bolts fixing the backrest connecting pin.Tighten the front bolt fixing the backrest to the vehicle floor.

Use the bolts specified by the manufacturer because longer bolts could interfere with the fuel tank.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR SEAT BACKREST JOINTS.	M10 x 1.25	35

Check that the engagement device is working properly.If necessary, adjust the striker    Op. 7050A45 STRIKER OF ONE SPLIT REAR SEAT SQUAB FASTENING RELEASE DEVICE ONE LH OR RH R R    Op. 7050A22 REAR SEAT CUSHION - R+R(left side)    Op. 7040B10 LOAD PLATFORM (LUGGAGE PLATFORM) TRIM - R+R.    Op. 7040H80 PARCEL RACK.