125000449 - A01 ALARM DOES NOT COME ON

When operating the alarm with the remote control: the LED does not flash; the doors do not open/close; the lights do not flash the siren does not emit auditory signals
Results of the tests
0PRELIMINARY CHECKSAll OKProblems metOperation
The activation of the auditory signals and flashing of the direction indicators depends on the various country modes.

Preliminarily check:

  • Charge of remote control battery incorporated in the key;
  • Key correct, i.e. remote control enabled
Continue to Step 1Remote control battery run downReplace the remote control battery
Key not correctConnect the test equipment to the tester connection and carry out correct memorization of the remote control
1CHECK WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation

Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket and check in order:

  • Presence of faults on the CAN network
  • Presence of faults in the alarm system
Continue to Step 2Presence of faults on the CAN networkRepair the connections on the nodes concerned
An error is detected in the alarm systemContinue following the instructions for the diagnostic equipment
2CHECK ON CORRECT OPERATIONAll OKProblems metOperation
Check that the fault is no longer presentEnd of diagnosis.