125000457 - A31 ALARM DOES NOT COME ON WHEN LUGGAGE COMPARTMENT IS CLOSED

When the alarm is on, the system will not come on again after one boot lid open/closure cycle.

One second after the boot lid opening command (via remote control), the system automatically reactivates if boot lid opening is not detected by turning volumetric, anti-tilt and perimeter protections back on.

		Results of the tests
1	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the diagnostic equipment to the body computer node and check boot lid status (open or closed) is properly received while in parameter mode.	Continue to Step 4	Boot lid status not received.	Continue to Step 2
2	ELECTRICAL CIRCUIT CHECK	All OK	Problems met	Operation
	Check that the electrical connection between boot lid switch and body computer node is not broken or insulated.	Continue to Step 3	Electrical conection broken or not insulated.	Restore continuity/insulation of the electrical connection between boot switch and body computer node. See    See E7015 ALARM
3	CHECKING COMPONENT OPERATION	All OK	Problems met	Operation
	Disconnect the connector on the body comuter node side and check for a boot open/closed signal. See    See E7015 ALARM	Continue to Step 4	Boot electrical switch not working	Change the boot catch Op.    Op. 7015B10 SINGLE TAILGATE LOCK - R+R OR REPAIR WITH PANEL/PROTECTION REMOVED
4	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present.	End of diagnosis	The fault persists	Replace the body computer node Op.    Op. 5505A32 BODY COMPUTER - R R