| | Results of the tests |
| 1 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Connect the Examiner tester and check that door and boot lid status (open/closed) is correctly received while in parameter mode. | Continue to Step 4 | Error in receiving door and boot lid status (open/closed). | Continue to Step 2 |
| 2 | ELECTRICAL CIRCUIT CHECK | All OK | Problems met | Operation |
|---|
| Check continuity/insulation of the connection between the body computer node and door/s and boot lid. | Continue to Step 3 | Electrical connection damaged. | Restore continuity/insulation of the damaged electrical connection. See See E7015 ALARM |
| 3 | CHECKING ELECTRICAL COMPONENT OPERATION | All OK | Problems met | Operation |
|---|
| Disconnect the connector, Body Computer Node side, and check for the door, boot lid and bonnet status signal (open/closed) See See E7015 ALARM. | Continue to Step 4 | Switch signalling door status not working | Replace the damaged switch Op. Op. 7005N21 FRONT SIDE DOOR LOCK MOTOR-LOCK ASSEMBLEY-R R |
| Switch signalling boot lid status not working | Replace the damaged switch Op. 7015B80 |
| Switch signalling bonnet lid status not working | Replace the damaged switch |
| 4 | Continue as instructed by the tester | All OK | Problems met | Operation |
|---|
| Check that the fault is no longer present. | End of diagnosis | The fault persists | Replace the body computer node Op. Op. 5505A32 BODY COMPUTER - R R |
