| | Results of the tests |
| 0 | CARRY OUT CLUTCH PARAMETER CALIBRATION USING THE EXAMINER | All OK | Problems met | Operation |
|---|
| In active diagnosis carry out the calibration of the clutch parameters through the ''clutch self-calibration enablement'' | Continue to Step 1 | The calibration is not successful | Continue in accordance with the instructions for the diagnostic equipment |
| 1 | CHECK THAT THE FAULT IS NO LONGER PRESENT | All OK | Problems met | Operation |
|---|
| Check that the fault is no longer present | End of diagnosis | The fault persists | Continue to Step 2 |
| 2 | CLUTCH PUSH ROD ADJUSTMENT CHECK | All OK | Problems met | Operation |
|---|
| Carry out the clutch push rod check as described in See Test See Test 2127M CLUTCH PUSH ROD ADJUSTMENT CHECK | Continue to Step 3 | The position is outside the permitted range | Restore the correct position Tighten to torque |
| 3 | AFTER THE CLUTCH PUSH ROD ADJUSTMENT | All OK | Problems met | Operation |
|---|
| Check that the fault is no longer present | End of diagnosis | The fault persists | Contact Technical Service for further information on the problem |