125000524 - G10 NO ACOUSTIC WARNING FOR HANDBRAKE APPLIED WITH VEHICLE MOVING
When the vehicle is moving, the accidental operation of the handbrake is not indicated by the acoustic signal. | The instrument panel node acquires from the network the signal indicating the status of the handbrake switch and the vehicle speed. If the handbrake is operated and the vehicle speed exceeds 4 km/h, an acoustic signal is emitted.Warning: This function can be enabled/disabled via the MODE +/- keys on the controls switch panel unit. Make sure that the function has not been disabled incorrectly by the user |
| Results of the tests | ||||
| 0 | PRELIMINARY CHECKS | All OK | Problems met | Operation |
|---|---|---|---|---|
| Connect the Examiner Plus or Smart diagnostic instrument and check, in the active diagnosis environment, that the buzzer is working properly | Continue to Step 1 | The buzzer is not working | Replace the Instrument Panel Node Op. Op. 5560B11 ANALOGUE CONTROL PANEL - R+R OR REPLACE | |
| 1 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
| Connect an Examiner and check the handbrake switch status has been correctly downloaded while in parameter mode | Continue to Step 3 | Malfunction in downloading of handbrake switch statuses | Continue to Step 2 | |
| 2 | ELECTRICAL CONNECTIONS CHECK | All OK | Problems met | Operation |
| Check the electrical connections between handbrake switch and Body Computer See See E4010 INSTRUMENT PANELAlso check that the handbrake switch is not faulty | Continue to Step 3 | Connections faulty | Restore the correct connections See See E4010 INSTRUMENT PANEL | |
| Handbrake switch faulty | Replace the handbrake switch Op. Op. 5550D18 HANDBRAKE ON WARNING LIGHT SWITCH - R+R | |||
| 3 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
Connect the Examiner and check on the body computer node:
| Continue to Step 4 | Error in the C-CAN line. | Continue following the instructions for the diagnostic equipment | |
| Error found in speedometer signal. | Continue according to the instructions inSee table See table K03 SPEEDOMETER NOT WORKING | |||
| 4 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
Keep the Examiner connected and check the body computer node for:
| Continue to Step 5 | Error found in the B-CAN line. | Continue following the instructions for the diagnostic equipment | |
| Error found in speedometer signal. | Continue according to the instructions inSee table See table K03 SPEEDOMETER NOT WORKING | |||
| 5 | ELECTRICAL CONNECTIONS CHECK | All OK | Problems met | Operation |
| Check the electrical connections between the instrument panel and Body Computer See See E4010 INSTRUMENT PANEL | Continue to Step 6 | Connections faulty | Restore the correct connections See See E4010 INSTRUMENT PANEL | |
| 6 | CHECK ON CORRECT OPERATION | All OK | Problems met | Operation |
| Check that the fault is no longer present. | End of diagnosis | The fault persists | Replace the Body Computer Op. Op. 5505A32 BODY COMPUTER - R R | |