| | Results of the tests |
| 0 | PRELIMINARY CHECK | All OK | Problems met | Operation |
|---|
| Check that the NAV CD is correctly insertd and recognized by the Connect. | Continue to Step 1 | NAV CD not inserted | Insert the NAV CD |
| NAV CD not recognized | Replace the NAV CD |
| 1 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Connect the Examiner diagnostic equipment to the diagnostic connector and check that there are no faults at the Connect Node in the errors ambient | Continue to Step 2 | Presence of faults | Continue according to the instructions for the diagnostic equipment |
| 2 | ELECTRICAL EQUIPMENT CHECK | All OK | Problems met | Operation |
|---|
| Remove the Connect and check that the aerial connector is correctly inserted in its housing. See See E4091 CONNECT | Continue to Step 3 | Connector disconnected from the Connect. | Insert the connector in its housing |
| 3 | ELECTRICAL EQUIPMENT CHECK | All OK | Problems met | Operation |
|---|
| Check the continuity/insulation of the connecting cable between the Connect and the G.P.S. aerial See See E4091 CONNECT | Continue to Step 4 | Aerial lead faulty | Renew the electrical connections See See E4091 CONNECT |
| 4 | CHECK ON CORRECT OPERATION | All OK | Problems met | Operation |
|---|
| Check that the fault is no longer present | End of diagnosis | Fault persists | Replace the aerial support |
