| | Results of the tests |
| 1 | FUSE AND RELAY CHECK | All OK | Problems met | Operation |
|---|
| Check the condition of the fuses and relays See See E3045 BOOT AND FUEL FLAP OPENING | Continue to Step 2 | Components faulty | Replace the component involved (if a fuse is involved, search for the cause of the problem) |
| 2 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Check the opening/closing of the boot through active diagnosis | Continue to Step 6 | The boot does not open/close | Continue to Step 3 |
| 3 | ELECTRICAL CIRCUIT CHECK | All OK | Problems met | Operation |
|---|
| Check the electrical connection between the body computer node, driver''s door node and the boot lock. See See E3045 BOOT AND FUEL FLAP OPENING | Continue to Step 4 | Electrical connector in boot lock not correctly connected | Connect the electrical connector to the boot lock correctly |
| Connections broken or not insulated | Restore continuity/insulation of the electrical connection See See E3045 BOOT AND FUEL FLAP OPENING |
| 4 | CHECKING ELECTRICAL SIGNAL | All OK | Problems met | Operation |
|---|
| Disconnect the boot lid lock electrical connector and check for a opening command signal. | Continue to Step 5 | Opening command signal absent. | Continue to Step 7 |
| 5 | Continue as instructed by the tester | All OK | Problems met | Operation |
|---|
| Check that the fault is no longer present. | End of diagnosis | The fault persists | Replace the boot lock motor Op. Op. 7015B70 TAIL-GATE LOCK MOTOR - R R AND CHECK LOCK SUPPLY LINE |
| 6 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Press the button in the dashboard and check, in the parameters ambient, at the Driver''s Door Node, that the boot lid opening button status changes | Continue to Step 9 | There is no change in the status | Continue to Step 7 |
| 7 | ELECTRICAL CIRCUIT CHECK | All OK | Problems met | Operation |
|---|
| Check the electrical connection between the switch in the dashboard and the Driver''s Door Node See See E3045 BOOT AND FUEL FLAP OPENING. Also check that the switch in the dashboard is working properly. | Continue to Step 8 | Connections broken or not insulated | Restore continuity/insulation of the electrical connection See See E3045 BOOT AND FUEL FLAP OPENING |
| Switch faulty | Replace the switch in the dashboard Op. 7015B80 |
| 8 | REPLACING DRIVER''S DOOR NODE | All OK | Problems met | Operation |
|---|
| Replace the Driver''s Door Node Op. 5505A42and check that the fault is no longer present | End of diagnosis | The fault persists | Restore the Driver''s Door Node and replace the Body Computer Node Op. Op. 5505A32 BODY COMPUTER - R R |
| 9 | CHECK ON CORRECT OPERATION | All OK | Problems met | Operation |
|---|
| Check that the fault is no longer present. | End of diagnosis | The fault persists | Replace the body computer node Op. Op. 5505A32 BODY COMPUTER - R R |