125000835 - 0010T12 ENGINE OIL AND FILTER REPLACE
 | The engine oil is harmful to skin: keep contact with skin to a minimum and if there is contact wash with soap and water. |
- Position the vehicle on a lift.
- Remove the filler cap with the engine hot.
- Release the engine oil dipstick.
- Undo the drain plug in the crankcase sump and leave the oil to drain into a suitable container.
| Be very careful when removing the drain plug, the oil could be very hot. |
| Do not let the oil disperse into the atmosphere as this could cause pollution. |
- Working from underneath the vehicle using the special key unlock the oil filter and remove it.
- Clean the drain plug and tighten the gasket to the recommended torque.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| - | ENGINE OIL DRAIN PLUG | M18 | (Crankcase sump side) 1.8 - 2.2 |
- Lubricate the new oil filter seal with engine oil and tighten it fully by hand.
- Refill the engine lubrication circuit with the recommended oil.
| Type | Component | Description | Qty. | |
|---|---|---|---|---|
| Oil [l] | ENGINE LUBRICATION SYSTEM | SELENIA 20K | 4.4 |
 | The table shows the quantity for periodic replacement. |
- For decidedly sporty use of the vehicle it is advisable to use the recommended oil for the engine lubrication circuit.
| Type | Component | Description | Qty. | |
|---|---|---|---|---|
| Oil [l] | ENGINE LUBRICATION SYSTEM | SELENIA RACING | 4.4 |
| The table shows the quantity for periodic replacement. |
- For the use of the vehicle in particularly severe climate conditions it is advisable to use the recommended oil for the engine lubrication circuit.
| Type | Component | Description | Qty. | |
|---|---|---|---|---|
| Oil [l] | ENGINE LUBRICATION SYSTEM | SELENIA PERFORMER MULTIPOWER | 4.4 |
| The table shows the quantity for periodic replacement. |
 | During the engine oil refilling operations, take great care to avoid letting the oil accidentally drop into the alternator ventilation slits which would damage it and create a fire risk. |
- Check that the engine oil level is correct using the dipstick.
| The oil level is checked with the vehicle on a flat surface. If the level of the oil is above the MAX reference this can cause excessive evaporation of the actual oil and a loss of pressure. |
- Fit the filler cap, let the engine idle for about 2 minutes, switch off the engine and then wait for several minutes.
- Check the oil level and make sure there are no leaks.
- Remove the vehicle from the lift.