125001075 - 1072B10 INLET MANIFOLD - R + R AND REPLACE SEAL

Removing ( Refitting )

• Position the vehicle on a lift.
• Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 Battery

•     Op. 1016A40 IGNITION COIL COVER ON CYLINDER HEAD- R+R
• Op. 1056B60 TUBO COLLETTORE COMBUSTIBILE UNICO, COMPLETO DI ELETTROINIETTORI - S.R.
•     Op. 1072D10 MODULAR INLET MANIFOLD - R+R

• Undo the bolts (1a) and remove the bracket (1b) connecting the intake manifold to the bracket on the engine for the reaction rod.

• Undo the nuts (1a) and remove the intake manifold (1b).

• Remove the gasket.

Refitting ( Removing )

• Place the intake manifold, complete with a new gasket, back in its housing and secure it tightening the nuts to the recommended torque.

	Fastening	Component	Ø	Value (daNm)
-	Nut	INLET MANIFOLD	M8	2.3 - 2.8, daNm

• Place the bracket connecting the intake manifold to the bracket on the engine for the reaction rod back in its housing and secure it using the bolts.
•     Op. 1072D10 MODULAR INLET MANIFOLD - R+R
• Op. 1056B60 TUBO COLLETTORE COMBUSTIBILE UNICO, COMPLETO DI ELETTROINIETTORI - S.R.
•     Op. 1016A40 IGNITION COIL COVER ON CYLINDER HEAD- R+R
• Connect the negative battery terminal (-).
• Remove the vehicle from the lift.