125001141 - 1080E28 ENABLEMENT SOLENOID FOR FLOW OF FUEL VAPOUR TO INLET - R+R

Removing ( Refitting )

• Position the vehicle on a lift.
• Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 Battery

•     Op. 1016A40 IGNITION COIL COVER ON CYLINDER HEAD- R+R
• Op. 1056B60 TUBO COLLETTORE COMBUSTIBILE UNICO, COMPLETO DI ELETTROINIETTORI - S.R.
•     Op. 1072D10 MODULAR INLET MANIFOLD - R+R

• Working at the bench, unscrew the bolts securing the solenoid enabling the passage of fuel vapours to the intake.
• Loosen the collars.
• Remove the solenoid enabling the passage of fuel vapours to the intake (3a) complete with pipe (3b).

Refitting ( Removing )

• Refit the solenoid enabling the passage of fuel vapours to the intake with its pipe and tighten the bands.
• Tighten the bolts securing the solenoid enabling the passage of fuel vapours to the intake.
•     Op. 1072D10 MODULAR INLET MANIFOLD - R+R
• Op. 1056B60 TUBO COLLETTORE COMBUSTIBILE UNICO, COMPLETO DI ELETTROINIETTORI - S.R.
•     Op. 1016A40 IGNITION COIL COVER ON CYLINDER HEAD- R+R
• Connect the negative battery terminal (-).
• Remove the vehicle from the lift.