1084A42 ENGINE OIL TEMPERATURE SENDER UNIT - R + R - Alfa - GT - eLearn

125001151 - 1084A42 ENGINE OIL TEMPERATURE SENDER UNIT - R + R

) Position the vehicle on a lift.Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Description	Connector
-	Battery	A1B

Proceed with the removal Op. 1072C44 EXHAUST MANIFOLD HEAT SHIELD ON BULKHEAD - R+R. Proceed with the removal Op. 1080B40 CATALYTIC PRE-CONVERTER - R R. 1. Unscrew the nut on the upper alternator bolt.2. Undo the bolts (2a) and remove the alternator rear mounting bracket (2b).

1. Disconnect the electrical connection from the engine oil pressure warning light switch.

	Description	Connector
1	Engine oil pressure sensor (switch)	K30

2. Undo and remove the engine oil pressure warning light switch.

Refitting ( Removing

) Place the engine oil pressure warning light switch in its housing and tighten it to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	-	INSUFFICIENT ENGINE OIL PRESSURE SWITCH	M14	(Engine crankcase side) 2.7 - 3.3

Connect the electrical connection to the engine oil pressure warning light switch.Refit the alternator bracket in its housing and secure it using the bolts.Tighten the nut on the upper alternator bolt. Proceed with the refitting Op. 1080B40 CATALYTIC PRE-CONVERTER - R R. Proceed with the refitting Op. 1072C44 EXHAUST MANIFOLD HEAT SHIELD ON BULKHEAD - R+R.Connect the negative battery terminal (-).Remove the vehicle from the lift.